However, returning to stable clock speeds removed the message.Įdit 2: I have already checked out, , and. What would be the exact issue causing this, and is there any way to get it resolved that doesn't involve RMA?Įdit 1: After unstable overclocks, the system would show a failure message stating that the ME FW is "abnormal". I assume that the motherboard's RAM slots are malfunctioning, but I can't be quite sure. I've tried putting a new, working, and stable module in, and it still shows me the same pattern. PSU: Generic brand 550w, tested with a Corsair as well, same problem. Whenever the RAM modules are inserted again, the same pattern of LEDs flash. If I boot with only the CPU (no RAM) the EZ Debug LED stays lit solid on DRAM, but when I connect the RAM, the EZ Debug LED starts to blink alternately between DRAM and CPU. This would easily explain your initial issue and would have been resolved very quickly had you asked at the time. The screenshot you provided, if it is your own, definitely shows an overclock applied to the system. That shows me at least that the CPU works. This suggests that the BIOS is incorrect or insufficient for the pairing you have. When the RAM modules are removed from the system and the power is turned on, the CPU is correctly detected, and the DRAM EZ-Debug LED remains on. It was a single pin on the margin of the socket and went completely unnoticed until I got a magnifying glass out and inspected it more thoroughly. About Ez Cpu Led And Debug Dram Blinking - there are no beeps when RAM is installed. It turns out that the cause of the issues was a bent pin in the CPU socket. Das MSI EZ Debug Led zeigt das Dram und Cpu abwechselnd blinken. However, after one attempt to overclock the RAM from 3200MHz to 3300MHz, the system shutdown and now flashes the EZ-Debug LED from a short CPU flash to a long DRAM flash (repeats). My embarrassment about how the problem was fixed may have been a factor. The USB and BIOS Flash LED flashed for about 5mins before the motherboard seemingly restarted. I am posting this after resolving the same error - MSI MPG B560I Gaming edge wifi. I was overclocking the RAM to 3300MHz from a base 3200MHz, and managed to get the system to boot, albeit unstable. MSI CPU & DRAM EZ Debug Red LED Fixed FIXED Yeaah. Internal hardware examples include the CPU, RAM, or a graphics card. A couple of bumps here and there, especially after attempting to overclock the RAM, but the system was running smoothly. A red light on your motherboard means internal hardware is either plugged-in incorrectly or not working. After adding a couple of 8GB RAM sticks to my already 16GB system, it worked fine.
0 Comments
Leave a Reply. |